型號XD-500打孔厚度35（mm）品牌現代牌打孔方式手動打孔個數3包裝方式紙箱泡沫包裝

xd-500三孔重型打孔機使用說明書

1.本機Zui大打孔厚度35mm，孔距83mm，孔徑5mm，亦可配4、6、7、8mm沖刀（需訂購）

2.依據紙張大小，調整前后左右靠山，設定正確打孔位置

3.經常檢查黑色沖孔墊，若有明顯凹痕，請用木枇按順時針或逆時針推動，若無新位置可打，必須更換

4.沖刀亦屬耗材，多次使用需適時更換

5.更換沖刀按圖示，用木枇逆向擰開m5沉頭螺絲，沖刀即脫開，換上新沖刀，擰緊螺絲

6.經常清理紙屑盒

operatinginstructions of xd-500puncher

1. maximumpunching thickness: 35mm, distance between holes: 83mm,

holediameter: 5mm (alternative: 4mm, 6mm, 7mm, 8mm)

2. adjust andfix the paper according to its size, to get accurate position ofthe holes.

3. check theblack padfre,turn it clockwise or counter-clockwise if necessary, and change itwhen it is broken.

4. punchingknife should also be changed when necessary.

5. whenchange pouching knife, please unscrew m5, change the knife, andthen tighten the screw m5 again.

6. pleaseclear the wastepaper box fre.

技術參數：

孔距：83mm

孔徑：5mm（4、6、7、8任選）

打孔能力：36mm（500張）