PP駐極母粒料N95

PP是一種半結晶性材料。它比PE要更堅硬并且有更高的熔點。由于均聚物型的PP溫度高于0℃以上時非常脆，因此許多商業的PP材料是加入1~4%乙烯的無規則共聚物或更高比率乙烯含量的鉗段式共聚物。共聚物型的PP材料有較低的熱扭曲溫度（100℃）、更高的透明度、低光澤度、低剛性，但是有有更強的抗沖擊強度。PP的沖擊強度隨著乙烯含量的增加而增大。PP的維卡軟化溫度為150℃。由于結晶度較高，這種材料的表面剛度和抗劃痕特性很好。PP不存在環境應力開裂問題。通常，采用加入玻璃纖維、金屬添加劑或熱塑橡膠的方法對PP進行改性。

PP的流動率MFR范圍在1~40。低MFR的PP材料抗沖擊特性較好但延展強度較低。對于相同MFR的材料，共聚物型的沖擊強度比均聚物型的要高。由于結晶，PP的收縮率相當高，一般為1.8~2.5%。并且收縮率的方向均勻性比PE-HD等材料要好得多。加入30%的玻璃添加劑可以使收縮率降到0.7%。均聚物型和共聚物型的PP材料都具有優良的抗吸濕性、抗酸堿腐蝕性、抗溶解性。然而，它對芳香烴（如苯）溶劑、氯化烴溶劑等沒有抵抗力。PP也不象PE那樣在高溫下仍具有抗氧化性。

PP plastic use / application examples: film, injection molding,blow molding, extrusion coating, stretching, fiber, sheet, bottlecap / NCR cloth, staple fiber, sheet, filament, BOPP film, IPPfilm, UV stabilized fiber, home appliance accessories, automotiveaccessories, household appliances, advanced Packaging (CPP,advanced packaging (CPP, transparent containers, large containers,ropes, high packaging (BOPP) , bags, , stationery, bottlecaps, fiber packaging, food containers, continuous fiber, Straw,daily necessities, disposable syringes, extrusion molding,printing, vacuum molding, tents, mixing, just as well as cloth PPmolding performance. Good li, but the shrinkage range andshrinkage value, prone to shrinkage. DENTS, deformations. Coolingspeed, pouring system and cooling system should slowly heat, andpay attention to control molding temperature. The direction of lowtemperature is obvious. When the mold temperature is lower than 50degrees, the plastic parts are not smooth, easy to produce badfusion, leaving marks, more than 90 degrees prone to warpagedeformation. 4. Plastic Wall thickness must be uniform, to avoidlack of glue, Sharp Angle, to prevent stressconcentration.