鐵路道釘錨固砂漿

railroad spike anchoring mortar

1特點features
鐵路混凝土軌枕、橋枕的道釘，大多采用硫磺錨固劑錨固。硫磺錨固道釘要熬制硫磺，對環境造成污染，施工也較麻煩；混凝土局部受熱可能產生裂縫，降低道釘使用壽命。td型道釘錨固劑是以無機混合料為原料的新型高強錨固材料，它具有快硬、高強、微膨脹、冷操作施工等特點。特別是省去加熱工序，對環境無污染，避免了現場施工的火災隱患。軌枕道釘錨固后，經200萬次疲勞試驗效果良好。

concrete sleeper railway bridge pillow of the spike, mostly usingsulfur anchor anchoring agent. sulfur anchor spike to be brewedsulfur, resulting in environmental pollution, construction, aremore trouble; concrete cracks of local heat may reduce the spikelife. td-type spike anchoring agent is a mixture of inorganic rawmaterials, new high-strength anchoring material, it has a fasthardening, high strength, micro-swelling, cold operation ofconstruction and so on. in particular, eliminating the need forheat treatment, environmental pollution, to avoid construction-sitefire hazard. sleeper anchor spike up after two million times offatigue tests are positive.
2使用范圍usage
2.1.鐵路混凝土軌枕、橋枕的道釘錨固；

railway concrete sleeper, the bridge pillow of the spike anchor
2.2.裝配式橋梁的膠結接頭的錨固；

prefabricated bridges anchoring cemented joints
2.3.機械設備地腳螺栓的錨固；

. machinery and e anchor bolts for anchoring
2.4.混凝土結構加固工程中牽釘?shù)腻^固。

concrete structure reinforcement project pull nail anchor
3主要技術指標technicalindicators

抗壓強度（mpa）compressivestrength (mpa)

抗拔力（kn）pulling force(kn)

4小時

1天

3天

13

＞20

＞35

＞50

＞60

20

＞25

＞40

4使用方法use

1.清除孔內雜物、粉塵及污染物。

clearance hole debris, dust and contaminants
2.在錨固孔底用木塞、粘土等堵嚴，防止漏漿。道釘?shù)腻^固深度不得小于150mm。

in the end of anchoring holes with cork, clay, etc. block strict,to prevent slurry leakage. spike anchoring depth of not less than150mm.
3.清除道釘表面的鐵銹、油污。

remove spike surface rust, grease
4.將錨固劑倒入攪拌鍋內，稱取錨固劑重量13～14%的水，與錨固劑一起拌合2～3分鐘。

will be anchoring agent into the mixing pot and said anchoringagent to take the weight of 13 ~ 14% of the water, mixing togetherwith the anchoring agent 2 ~ 3 minutes.
5.將拌合均勻的錨固劑，灌注入道釘予留孔中，用搗固捧搗實。

the mixing uniform anchoring agent, filling the hole into the spiketo the left, using tamping tamping moral support.
6.將道釘從灌注孔上部旋轉壓入灌滿錨固劑的孔正中，套入道釘定位板，用另一根道釘輕輕敲擊道釘頭部，使錨固劑振動密實。

will spike from the perfusion pressure into the hole filled withrotating upper anchoring holes in the middle of agents, set spikeinto the positioning plate, gently tapping with another root spikespike head, so that vibration compacting anchoring agent.
7.當錨固劑硬化抗壓強度＞35mpa時，即可受力。
when the anchoring agent hardening compressive strength> 35mpa,they can force.
5　注意事項notes
1.td型道釘錨固劑可在低溫或負溫條件下使用，但由于氣溫較低，硬化時間加長。

td-type low-temperature spike anchoring agent can be used under ornegative temperature conditions, but because of the lowertemperatures, curing time longer.
2.當在絕緣要求較高的線路上使用時，需經有關部門認可。建議使用絕緣套管或在道釘上涂抹絕緣膠。

when the insulated lines re high use should be subject toapproval by relevant departments. recommend the use of insulatingsleeve or insulating plastic spike on the smear.
3.td型道釘錨固劑應防止受潮，受潮的錨固劑不得使用。其有效期為一年。

td-type spike anchoring agent should prevent the damp, wetanchoring agent shall not be used. is valid for one year.