義烏義烏煤氣灶維修檢測漏氣 

點火器不產生火花：在使用時，發現打開煤氣灶，但噴火器沒有火噴出，屬于故障情況。這是因?yàn)樽匀稽c(diǎn)火器的壓電陶瓷正機不產生火花，使灶盤不能發火。故障主要是由自動開關接向壓電陶瓷正極的導線因饒毀而斷路，可重新用導線可靠連接。另外，如果壓電陶瓷正極被沾污或銹蝕而造成接觸不良，也會造成點火困難，這時可抽出金屬圓棒，用細砂紙擦去污垢后再插入。、有火花但不能引燃：打開煤氣灶，發現火花噴出，但不能引燃煤氣，這也屬于故障。原因在于壓電陶瓷正極與灶盤負極間距離太遠或太近，就會使火花不能引燃煤氣，應把距離調整到4毫米左右。另外在近點火器一側的燃?xì)鈬娮毂灰娉鑫锘蚱渌愇锒氯矔?huì)造成點不著火或點火困難，這時只要清除噴嘴內的堵塞物即可。

The igniter does not produce sparks: when using, it isfound that the gas stove is turned on, but the flamethrower doesnot emit fire, which is a fault condition. This is because thepiezoelectric ceramic positive mechanism of the natural igniterdoes not produce sparks, so that the cooker cannot ignite. The mainfault is that the wire connected to the positive pole ofpiezoelectric ceramic by the automatic switch is broken due tobreakage, which can be reliably connected with the wire again. Inaddition, if the positive electrode of piezoelectric ceramic iscontaminated or rusted, resulting in poor contact, it will alsocause difficulty in ignition. At this time, pull out the metalround rod, wipe the dirt with fine abrasive paper, and then insertit Spark but can't ignite: open the gas stove and find that thespark is ejected, but can't ignite the gas, which is also a fault.The reason is that the distance between the positive electrode ofthe piezoelectric ceramic and the negative electrode of the cookerplate is too far or too close, which will make the spark unable toignite the gas. The distance should be adjusted to about 4mm. Inaddition, the gas nozzle on the side near the igniter is blocked byoutflow or other foreign matters, which will also cause ignitionfailure or ignition difficulty. At this time, it is only necessaryto remove the blockage in the nozzle.